How do you install a front license plate on a 2002 Honda Civic? - how to install front license plate honda
If you do not get a front plate bracket, you can visit a Honda dealership and try to buy one ..... or you suck your pride and holes in the bumper. I recommend trying all means to spend a record Braket first place.
Sunday, January 24, 2010
How To Install Front License Plate Honda How Do You Install A Front License Plate On A 2002 Honda Civic?
Subscribe to:
Post Comments (Atom)
7 comments:
You can activate the 2 screws above the number plate on the front of the bumper. If you look closely, indicators, where the set screws can be found on the front bumper. This would be the quickest and easiest method.
Or, if you have purchased a support or a tray, you can) a piece from the underside of the bumper (Screw you should see a place for the screw in the center right under the bumper and turn 2 small screws at the bottom of your tuition for the support you need, down by 2 nuts behind the grease on the plate in the fixture to run down. It looks good and keeps it with drilling bumper, but can be a problem if you balance and the level from time to time.
Good luck!
You can activate the 2 screws above the number plate on the front of the bumper. If you look closely, indicators, where the set screws can be found on the front bumper. This would be the quickest and easiest method.
Or, if you have purchased a support or a tray, you can) a piece from the underside of the bumper (Screw you should see a place for the screw in the center right under the bumper and turn 2 small screws at the bottom of your tuition for the support you need, down by 2 nuts behind the grease on the plate in the fixture to run down. It looks good and keeps it with drilling bumper, but can be a problem if you balance and the level from time to time.
Good luck!
Everything you need to do is to create a brand to have. Hold the plate in the bumper where you want to keep it in the middle and level. Through the two holes of the plate, was with his brand markers. You need two screws that you have to get down a drill bit that is slightly smaller than the screws. Drill two holes where your marks are, why they are on, and the screws on the plate.
U Put tighten the screws into the holes and the screws.
"Only the board and forget."
I would not recommend. In some states is illegal and you can get a ticket for him.
You can simply contact your local Honda dealer and ask the parts department for assistance prior to registration. There, you will receive. If less than $ 20 with the console, accessories and installation instructions.
If you do not have license plate support, you can and you drill the correct holes in the bumper or just holes in the plate bumpers.
Just to throw on the board and forget.
Post a Comment